- Mechanical Seal Auxiliary System
- Reactor Mechanical Seal
- Mechanical Seals for Chemical and Pharmaceutical Industries
- Special Mechanical Seal for Flue Gas Desulfurization
- Special Mechanical Seal for Coal Washing and Smelting
- Mechanical Seals for High-speed Reactors
- Bottom-entry Special Mechanical Seal
Plan52 mechanical seal auxiliary system (buffer tank/balance tank)
Structural characteristics
●Main structure: The tank body is made of stainless steel (such as 304, 316L) and has good corrosion resistance.
●Functional components: integrated liquid level sight glass (for observing the buffer liquid level), cooling coil interface (optional, used to control the buffer temperature), pressure/liquid level detection interface (can be installed with monitoring elements such as pressure gauge and liquid level switch) and pipeline valve (to achieve buffer circulation control).
●Circulation design: The buffer solution can be circulated naturally between the sealed chamber and the buffer tank through a pumping ring or thermal siphon effect, without the need for an external power source.
●Safety design: Equipped with high-pressure and low-liquid-level alarm devices, it can monitor the sealing operation status in real time and promptly warn of failure risks.
Working parameters
●Pressure: The buffer pressure is close to atmospheric pressure (usually ≤0.1MPa), and the system design pressure can reach 5MPa (some customized models are higher).
●Temperature: Applicable temperature range is -60℃~400℃. The buffer temperature can be controlled at 8℃~16℃** through the cooling coil (for high temperature media scenarios).
●Capacity: Common working volumes are 12L and 20L (6L~25L specifications can be customized according to needs).
●Linear speed: Suitable for working conditions where the mechanical seal linear speed is ≤25m/s.
Applicable media
●The buffer medium must be compatible with the process medium, commonly clean water, ethylene glycol solution, special isolation fluid, etc.
●Applicable process media include light hydrocarbon volatile media (such as vinyl chloride, carbon monoxide), low-risk toxic media, high-risk fluids containing particulate impurities, etc.
Application Areas
●Petrochemical industry: Double-end mechanical seal auxiliary system for centrifugal pumps, compressors and other equipment used to transport flammable, explosive and toxic media.
●Energy and Power: Ensure “zero leakage” of seals in pump equipment (such as slurry pumps and process pumps) operating under high temperature and high pressure conditions.
●Environmental water treatment: Suitable for sealing protection of sewage pumps, sludge pumps and other media containing impurities.
Special Instructions
●Installation requirements: The buffer tank must be installed vertically 305~735mm above the pump centerline, with a horizontal distance of ≤900mm, and the pipeline must maintain an upward slope of ≥10mm/240mm to avoid gas accumulation.
●Operational specifications: When starting, you must first turn on the Plan52 system, fill the buffer solution, and then start the main pump; when shutting down, you must first stop the main pump, delay for 5 minutes, and then turn off the buffer solution circulation and cooling system (the high-temperature medium pump needs to be manually turned every 30 minutes until the temperature drops to a safe range).
●Maintenance points: Check the cleanliness of the buffer regularly. If the medium contains particles or is easy to crystallize, a filtering device should be added at the front end. When the liquid level drops by more than 10%, the liquid should be replenished in time to avoid circulation interruption and overheating of the seal.




