- Mechanical Seal Auxiliary System
- Reactor Mechanical Seal
- Mechanical Seals for Chemical and Pharmaceutical Industries
- Special Mechanical Seal for Flue Gas Desulfurization
- Special Mechanical Seal for Coal Washing and Smelting
- Mechanical Seals for High-speed Reactors
- Bottom-entry Special Mechanical Seal
Double mechanical seal for 207 type kettle
Structural characteristics
●Double-end design, multi-spring balanced structure, the medium end is unbalanced and the atmosphere end is balanced (UB type).
●Adopting transmission sleeve/lug transmission, the spring pressure is evenly distributed, the axial size is compact, and the compensation component is pre-assembled as a whole, which is convenient for installation.
●A sealing liquid circulation system (such as an isolation liquid tank) is required. The sealing liquid pressure should be 0.05~0.2MPa higher than the medium pressure to achieve two-way sealing protection.
Working parameters
●Pressure: Sealing chamber pressure ≤1.6MPa, medium pressure ≤1.5MPa (after sealing hydraulic pressure differential compensation)
●Temperature: -40℃~250℃ (high temperature working conditions require a cooling system)
●Linear speed: ≤20m/s
●Speed: ≤500r/min
●Shaft diameter: φ30mm~φ160mm
Applicable media
Flammable, explosive, and toxic media (such as organic solvents and hydrocarbons), highly corrosive media (acids, alkalis, and salt solutions), chemical liquids containing particles (particle content ≤ 25%), and clean media with "zero tolerance" for leakage (such as the pharmaceutical and food industries).
Application Areas
●Reactor: Enamel reactor, stainless steel high-pressure reactor, stirring shaft seal of stirring kettle.
●Chemical equipment: vertical rotating shaft seals of distillation towers, fermentation tanks, and storage tanks.
●Industry coverage: Strict sealing scenarios in petrochemical, pharmaceutical, food, environmental protection, metallurgy and other fields.
Special Instructions
●During installation, the verticality between the kettle flange and the shaft must be strictly checked (≤0.1mm), and the surface roughness of the shaft diameter must be Ra≤3.2μm.
●The sealing liquid must be compatible with the medium. For granular medium working conditions, it is recommended to use silicon carbide to silicon carbide friction pairs to enhance wear resistance.
●When the pressure is greater than 0.4MPa, a pressure balance tank must be installed. When the temperature is greater than 180℃, a cooling water tank must be added and the installation height must be increased (approximately 80mm).





